Oscilloscope GDS-2104A, Oscilloscope GDS-2104A

Chi tiết sản phẩm

Oscilloscope GDS-2104A

Channels	4CH+Ext
Bandwidth	DCvn_100MHz (-3dB)
Rise time	3.5ns
Bandwidth Limit	20MHz
Vertical Sensitivity
Resolution	8 bit
Resolution	:1mV*vn_10V/div
Input Coupling	AC, DC, GND
Input Impedance	1MΩ// 16pF approx.
DC Gain Accuracy	±(3% X \|Readout\| + 0.1div + 1mV)when 2mV/div or greater is selected ±(5% X \|Readout\| + 0.1div + 1mV)when 1mV/div is selected;
Polarity	Normal & Invert
Maximum Input Voltage	300Vrms, CAT I (300Vrms CAT II with GTP-151R/251R/351R/501R 10:1 probe )
Offset Position Range	1mV/div vn_ 20mV/div : ±0.5V
	50mV/div vn_ 200mV/div : ±5V
	500mV/div vn_ 2V/div : ±25V
	5Vvn_10V/div : ±250V
Waveform Signal Process	+, -, ×, ÷, FFT, FFTrms ,d/dt ,∫dt ,√ ,Integration, Differentiation *: App installation required”
Trigger
Source	CH1 ,CH2, CH3, CH4
Source	Line, EXT, D0-D15**
Holdoff range	10nsvn_10s
Coupling	AC,DC,LF rej. ,HF rej. ,Noise rej.
Sensitivity	DC vn_ 100MHz Approx. 1div or 1.0mV
	100MHz vn_ 200MHz Approx. 1.5div or 15mV
	200MHz vn_ 300MHz Approx. 2div or 20mV
External Trigger
Range	±15V
Sensitivity	DC vn_ 100MHz Approx. 100mV
	100MHz vn_ 200MHz Approx. 150mV
	200MHz vn_ 300MHz Approx. 150mV
Input Impedance	1MΩ±3%vn_16pF
Horizontal
Time base Range	1ns/div vn_ 100s/div (1-2-5 increments)
Time base Range	ROLL: 100ms/div vn_ 100s/div
Pre-trigger	10 div maximum
Post-trigger	1000 div maximum.
Time base Accuracy	±20 ppm over any ≥ 1 ms time interval
Real Time Sample Rate	Max.:2GSa/s
ET Sample Rate	100GSa/s maximum for all models
Record Length	Max:2Mpts
Acquisition Mode	Normal, Average, Peak Detect, Single
Peak Detection	2ns (typical)
Average	selectable from 2 to 256
X-Y Mode
X-Axis Input	Channel 1; Channel 3*
X-Axis Input	*four channel models only
Y-Axis Input	Channel 2; Channel 4*
	*four channel models only
Phase Shift	±3° at 100kHz
Display
TFT LCD Type	8" TFT LCD SVGA color display
Display Resolution	800 horizontal × 600 vertical pixels (SVGA)
Interface
RS232C	DB-9 male connector X1
USB Port	USB 2.0 High-speed host port X2, USB High-speed 2.0 device port X1
Ethernet(LAN) Port	RJ-45 connector, 10/100Mbps with HP Auto-MDIX (option)
Go-NoGo BNC	5V Max/10mA
Logic Analyzer (Option)
Sample Rate	500MSa/s
Bandwidth	200MHz
Record Length	2M max
Input Channels	16 Digital (D15 - D0) or 8 Digital (D7vn_D0)
Trigger type	Edge, Pattern, Pulse Width, Serial bus (I2C, SPI, UART),parallel
Thresholds	Quad-D0vn_D3, D4vn_D7 ,D8vn_D11* ,D12vn_D15* (*:DS2-16LA only)
Threshold selections	TTL, CMOS, ECL, PECL, User Defined
Threshold accuracy	±100mV
User-defined Threshold Range	±10V
Maximum Input Voltage	±40 V

Danh mục tham khảo:

THIẾT BỊ SỬA CHỮA